Brightsign Diagnostic Web Server User Guide FW v. 5.1.54 Uživatelský manuál stáhnout pdf (Strana 7)

USING THE DIAGNOSTIC WEB SERVER

The Diagnostic Web Server user interface consists of

several tabs. This chapter will detail the information and

settings offered by each tab.

Info

This page provides general information about the player

and its current status:

• Time: The current time as it is configured on the

player. Click set to configure the time on the player:

o Automatically: Click Use Current Time to set the

time of the player using the current time of the

browser. Note that the listed Time and Date refer

to the time reported by the browser when this

page was loaded.

o Manually: Enter a Time and Date to set on the

player. These values will go into effect the moment

you click the Set Time button. If you would like to

interpret the date/time using the time zone of the

player, check the Apply Timezone box.

Otherwise, the date/time will be applied as a UTC

value.

Note: You cannot edit the time zone of the player from

the DWS. To change the time zone, you will need to

perform the player setup process again.

• Name: The user-supplied name of the player

• Description: An optional user-supplied description for

the player

• Model: The model number of the player

• Unique ID: The serial number of the player

• (Ethernet/WiFi) IP: The IP address of the player

• (Ethernet/WiFi) MAC: The media access control

(MAC) address of the player

• Boot Version: The current version of the boot loader.

• Firmware Version: The current version of firmware

installed on the player

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Brightsign Diagnostic Web Server User Guide FW v. 5.1.54 Uživatelský manuál Strana 7