Brightsign HD2000 Hardware Guide Uživatelský manuál stáhnout pdf (Strana 7)

BrightSign HD2000

This information applies to a product under development. Its characteristics and specifications are subject to change without notice. Roku assumes no

obligation regarding future manufacturing unless otherwise agreed to in writing. www.rokulabs.com

19 Button 8 input 20 Button 7 input

21 Ground 22 Button 4 input

23 Button 2 input 24 Ground

25 Button 0 input

The following Diagram shows how to wire up a button and LED to each input/output (this is the

schematic of the Roku button/led board that we sell for development use). You of course can use as little

or as many of the inputs and outputs as you wish.

Ethernet

The HD2000 has a standard RJ45 connector for 10/100 base T Ethernet. The pinout of the RJ45 is as

follows (NOTE: This pinout is only accurate for REVC and later HD2000 boards, REVB has a hardware

bug in this pinout):

pin Description pin Description

1 TX+ 2 TX-

3 RX+ 4 RC to ground

5 RC to ground 6 RX

7 RC to ground 8 RC to ground

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Žádné komentáře

Brightsign HD2000 Hardware Guide Uživatelský manuál Strana 7